Industry Info

Problems and Solutions in the Use of Organic Fertilizer Drying Machine

2023/12/14
 Organic fertilizer dryers play an important role in the production of organic fertilizer production lines, but in the process of use, there will inevitably be some failures. This article will introduce some common organic fertilizer dryer failures and troubleshooting methods to help you better maintain and use the dryer.
A section of secondary granulation area is set at the front of the organic fertilizer dryer, in which the materials can realize secondary granulation. Then the materials are lifted up through the lifting plate and fully dried. The wet hot air is extracted from the tail of the dryer through the exhaust fan through the pipeline and enters the sedimentation chamber for sedimentation. The tail gas is sprayed to reduce dust through the washing tower after sedimentation. The spray water is pumped out by the water pump for recycling. After secondary dust reduction treatment, the tail gas is discharged into the atmosphere through the chimney.

First, the 
Organic fertilizer dryers does not work
Cause: The power cable is loose or damaged.

Solution: Check whether the power cable is loose. If yes, reconnect it.

Second, the drying effect is not good

Fault cause: material humidity is too high or drying temperature is not uniform.

Solution: Adjust the material humidity to ensure that the material water content is within the appropriate range. At the same time, check the dryer temperature control system to ensure uniform temperature distribution.

Third, the noise of the dryer is too large

Cause of failure: the internal parts of the dryer are worn or loose.

Solution: Disassemble the dryer, check whether the internal parts are loose or wear, and replace or repair in time.

Four, the dryer vibration is too large

Failure cause: the foundation of the dryer is not firm or the body weight is too large.

Solution: Strengthen the dryer base to ensure its stability. At the same time, check that the dryer is installed correctly to ensure that the weight is evenly distributed.

5. Abnormal heating of the dryer

Fault cause: the heat dissipation system of the dryer is faulty.


Products
Tel
contact
inquiry